-Signal fault: (valid for RSat and RMK) behaviour setup of the satellite
receiver in case of signal loss.
- Individual set: the behaviour of the output in case of a signal loss will
be conducted by the setup of particulat
channels in the menu Measurement/Setup – Setup of the output,
where the behaviour of particular output channels
in case of signal loss may be set – to repeating of the last deviation or
to FailSafe.
in case of signal loss, - Output switching off: after the elapse of the set
time in the menu FailSafe Retard there
will exist no more PPM pulse generation at the receiver output.
- Menu display: allows menu setup in full or reduced shape. In the
reduced menu display are for the sake of setup
simplification some of the selected items not shown. But all receiver
setups are taken into account, even the given
item is not shown in the reduced menu.
Channel set: parameter setup of (received) individual input channels
CH
-Set Input Channel: selection of the input channel which has to be set
up, value A represents the actual throw of
the selected input channel.
-Set Center: neutral position setup of the input channel, this
parameter is important for further processing of
mixers, reverse, gain etc.
-Mix CHa and CHb: makes mixing of the selected channel with another
channel feasible.
-Mix Relation: setup of the mixing ratio, the mixed channel always
features a ratio of
50 %. For instance, mixing of CHa and CHb with a ratio of 100% =
50% CHa and 50% CHb, a ratio of 50% = 50% CHa
and 25% CHb, a ratio of 200% = 50% CHa and 100% CHb.
-Mix Sign: the first sign of the mixed channel specifies whether the
channels are subtracted or added
Out Pin Set: Relation of functions to individual output channels (pins)
Y of the receiver.
-Set Output Pin: Selection of the output channel whose setup you want
to show or change.
It is possible to add to a R10, R12, R14, R18 Duplex receiver two
satellite receivers or further R10, R12, R14, R18
receivers. In case of the Duplex R18 (R12) receiver it is possible to
switch output Y17 (Y12) to the function Sat2 and
output Y18 to Sat1. The output channel marked Sat 2 may be set to
receiving mode or to generation of PPM signals.
