9
Squeeze \ scratch hazard. There is a risk of being crushed by touching any moving part.
Only handle pre-designed for output is allowed to be touched.
Do not reach into the opening of the coffee bean trough, powder trough, or brewer after starting the
coffee machine.
The blades on the grinder disk and the coffee trough opener blades are sharp and should be taken
care of during cleaning.
2.2
Hazards to machines
Improper use of the coffee machine can cause damage or contamination.
Be sure to follow the following:
If the carbonate contained in the water is harder than 5°DKH, install a scale filter, otherwise it will
damage the coffee due to calcification.
For safety reasons, please note that the main water valve (coffee machine with tap water interface)
should be turned off after shutdown, and the main switch should be turned off or the plug should be
unplugged.
Please comply with the relevant low voltage directives and/or national and local safety rules and
regulations.
If water injection is not possible, do not turn on the device. Otherwise you will not be able to refill the
water boil and the pump will run "dry".
It is recommended to install a ball valve in the water pipe when connecting to the direct drinking
water to avoid water seepage hazards when the hose breaks.
After a long shutdown (such as a corporate holiday), the coffee machine must first be cleaned and
then turned back on for use.
Protect the coffee machine from weather - empty the tank (frost, moisture, etc.).
Troubleshooting should only be done by a technical service person.
Use original parts for repairs.
For visible external damage or leakage, contact your service partner immediately for replacement or
repair.
Do not rinse the machine with water or clean it with steam cleaner.
Do not place the machine where it may be sprayed with water.
Protect the ground.
If you do not use the machine for a long time, it is recommended to use up all the coffee beans in
the bean warehouse, otherwise the residual coffee beans will absorb water in the air, and it is easy
to cause the grinder to block when grinding again;
If the boiler is not regularly descaled, it will have the following effects: the heating speed slows down
and the temperature is not enough; Abnormal coffee taste, resulting in boiler damage.