CWF-50 Cold Wire Feeder
- 8 -
e. Insert the outlet guide/conduit as-
sembly into the drive roll assembly.
Position it so the chamfered conduit
is very close to the drive rolls. (Make
sure the end of the outlet guide is
clear of the drive rolls.) Tighten the
outlet guide securely by turning the
hand knob.
f. Run the conduit to the torch as re-
quired. Remember sharp twists and
turns affect the flow of the wire. Test
the path of the conduit with the torch
in its fully retracted and extended
positions.
If the conduit is too long, cut the
end, making sure it is completely
deburred.
g. Strip 4” (100 mm) of the outer cover
on the conduit. Slide the bare con-
duit into the wire guide tip. Tighten
the set screw holding the conduit
securely into position.
Note: On a rare occasion, you may
have to pull this end of the conduit
from the tip when initially feeding
wire. Let the wire extend about 6”
to 8” (150 to 200 mm) beyond the
conduit and then feed the wire into
the tip until the conduit is back into
normal position.
The wire guide tip is held in position by
a set screw. The tip can slide into the
clamping mechanism on the WGP-1 Wire
Guide Positioner.
5.
Electrical Connections:
As standard, the feeder is shipped with
an electrical connector and 6 ft. (1380
mm) cord suitable for 115 volts 50/60 Hz
power supply. Operation for 220 volts is
configurable.
If you need to start the wire feeder from
a remote signal, you must supply a nor-
mally open, maintained contact closure
to Connector S2, Pins A and B.
Summary of Contents for 070159
