2. Gas Specifications
Jetmaster Gas Convector fireplaces are
designed to burn LP Gas only. For proper
performance, LP Gas fires are set either
for use on the Highveld or coastal regions.
Check the markings on the outside of
the box in which the burner is delivered
to make sure you have the correct burner
for where you stay. Do not take a Highveld
burner to the coast or vice versa. Do
not burn LP Gas on a Towns Gas burner
or vice versa.
3. Regulations
The installation of this Gas Convector
must be carried out fully in accordance
with these Installation Instructions, which
comply with the current regulations of
the Liquid Petroleum Gas Association of
Southern Africa (LPGAS Association).
The gas fitting connection and testing
part of the installation must be carried
out by a fitter registered with the
SAQCCI.
The following documents have references
which apply to the installation of this gas
fireplace, and the relevant clauses must
be applied:
SABS 1539: 2001:
Appliances operating on LP Gas portable
and mobile appliances; safety aspects.
SABS 087 Part 1: March 1999:
Consumer LP Gas cylinder installation.
SABS 087 Part 2: 1975:
Installation in mobile units and small
non-permanent dwellings.
SABS 087 Part V11: 1997:
Retail outlets and similar gas filling sites
for small cylinders.
SABS 0400:
Building Regulations.
SABS 1237: March 1990:
Single stage low pressure regulators for
LP Gas.
Fire Department:
Safety guidelines.
Building Inspectors for the
planning of the installation.
Occupational Health and Safety
Act 1993.
4. Deviations from Instructions
Consult with Jetmaster PRIOR to
commencing installation, if any deviation
from these guidelines is being considered.
Failure to do so may result in an illegal,
dangerous and uninsured fitting and will
invalidate your Jetmaster Warranty.
550, 700 & 850 GAS CONVECTOR
INSTALLATION & OPERATING INSTRUCTIONS
INSTALLATION & OPERATING INSTRUCTIONS
4
INSTALLATION AND OPERATING INSTRUCTIONS:
550, 700 & 850 DE LUXE
