Page 11
6. General use
Attaching optional fire screen
To attach the firescreen,
1.
place either the left or right side hook in between the outer flange and the lowest part of the upper
deflector where it meets the flange.
2.
Raise the opposite side to the top corner of the upper corner to locate the alternate hook inside
the flange.
3.
Lower into place. For removal, follow the opposite of this instruction.
General usage info
How to use the wood fireplace
Your Jetmaster fireplace is designed not to spill smoke and by following a few instructions you will achieve optimum heat output,
convenience and fuel economy. Please note that during the first fire the paint goes through a bonding process called curing which
may emit odours. This is normal and it is recommended to open windows to outside to allow the fumes to disappate.
Lighting a fire
There are many different ways to successfully light and run a fire all of which require an even balance of the 3 elements of combustion.
Fuel, Heat (ignition source) and Oxygen - if your fire is not operating cleanly it will be due to one of these elements being
compromised. Jetmaster recommends the Home Heating Association website
www.homeheat.com.au
as a terrific resource for further
information on tips and FAQ’s on solid fuel troubleshooting.
1.
Ensure the damper is in the full open position. Pull the handle on the left side towards you with the steel handle provided.
2.
In firebox lay your fire lighters 10 to 15 centimetres apart, depending on the size of your firebox. Do not use newspaper as a
fire lighter. On units that are installed with a dual spigot gather, it is recommended to light 2 fires directly underneath the two
separate flues.
3.
Add soft wood kindling in a criss cross pattern above the firelighters. Softwood kindling allows for fire to light quicker and
burn hotter.
4.
Light fire with match or gas lighter. Leave for 5-10 minutes maximum and do not leave unattended.
5.
Load pieces of hardwood that are no wider than a drink can in a criss cross pattern.
6.
After 30 minutes add the large pieces of hardwood. These pieces should be no bigger than a loaf of bread. You may attach
your screen now if desired.
7.
After 45 minutes you can adjust the damper to slightly slow the fire down. The amount you can close it will depend on the
type of wood used and general weather conditions.
If the fire begins to spill smoke, adjust the damper to a more open position. Do not close the damper more than 50% when the fire is in
operation. Once the fire is extinguished, closing the damper will reduce cold drafts and heat loss associated with the open flue.
Always leave a bed of ashes up to the centre crest of the logpan for ease of lighting and to prolong the life of and protect the logpan.
Excess ashes should be removed when necessary, placed in a non-combustible container with a tightly fitting lid and moved outdoors
immediately to a location clear of combustible materials.
1
2
3
