Page 14
Bullfrog Spas Owner’s Manual
The start-up temperature is set at 100°F. The last measured temperature is constantly displayed on the LCD.
Note
that the last measured spa temperature displayed is current only when pump 1 (“Jets 1” )has been running
for at least 2 minutes
.
Press the “Warmer” or “Cooler” button to display and adjust the set temperature. After three seconds, the LCD will
automatically display the last measured spa temperature.
Jets 1
Touch the “Jets 1” button once to activate the low speed of
pump 1 and again for the high speed. Press the “Jets 1”
button again to turn off pump 1. If left running, the
pump’s low speed will automatically turn off after 2 hours,
and the pump’s high speed will automatically turn off after
30 minutes. The pump’s low speed runs when the spa is
heating, when a filter cycle is activated, or when a freezing
condition is detected. If the pump’s low speed is on under
Automatic Spa Control, it can only be deactivated by
entering the Standby Mode.
Note:
The Auxiliary Control Pad for “Jets 1” (optional) activates the
jets in the same manner as the Master Control Pad. (Fig. M)
Jets 2
Touch the “Jets 2” button once to activate the low speed of
pump 2 and again for the high speed. Press the “Jets 2”
button again to turn off pump 2. If left running, the
pump’s low and high speeds will automatically turn off
after 30 minutes.
Note:
The Auxiliary Control Pad for “Jets
2” (optional) activates the jets in the same manner as the
Master Control Pad. (Fig. L)
Light
Press the “Light” button to turn the light on and off. If left on, the light
automatically turns off after 4 hours.
Mode
This button is used to switch between Standard, Economy, and Sleep
Modes.
Standard Mode
is programmed to maintain the desired temperature. Note: the
last measured spa temperature displayed is current only when pump
1 has been running for at least 2 minutes. “
Std
” will be displayed
momentarily
when you switch into standard mode.
Economy Mode
heats the spa to the set temperature only during filter cycles. “
Ecn
” will display solid when
temperature is not current, and will alternate with temperature when temperature is current.
Push “Jets 1” to shift to Standard-in-Economy Mode, indicated by
“SE”
alternating with the temperature. The spa
operates the same as it does in Standard Mode, but reverts to Economy Mode automatically after 2 hours. During
this time, a press of the “Mode” button will revert to Economy Mode immediately.
Note:
Heating will occur more quickly in Standard-in-Economy Mode if a low-speed (versus a high speed) pump is operating.
Sleep Mode
heats the spa to within 20°F of the set temperature only during filter cycles. “
SLP
” will display solid
when temperature is not current, and will alternate with temperature when temperature is current.
Preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins 12 hours later.
Filter duration is programmable at the Master Control Pad for 2, 4, or 6 hours. The default filter time is 4 hours. To
program, press “Warmer” or “Cooler”, then “Mode.” Press “Warmer” or Cooler” to adjust. Press “Mode” to exit
programming.
Pump 2 purges for 5 minutes at the beginning of each filter cycle. The low speed of pump 1 runs during filtration
and the ozone sterilizer (if installed) will be enabled. If any button is pressed during filtering, the ozone sterilizer
(if installed) will be disabled for 30 minutes.
Temperature Display Inversion
(Figure K-2) Deluxe Control Pad
(Figure K-1) Deluxe Control Pad
(Figure L) Auxiliary Control Pad
(Custom models only)