Page 17
Bullfrog Spas Owner’s Manual
Temp Set (80°F - 104°F / 26.0°C - 40.0°C)
The start-up temperature is set at 100°F/37.5°C. The last measured temperature is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only when the pump has been running for
at least 2 minutes.
SELECT CONTROL SYSTEM (BF01)
The pump responsible for heating and filtration (pump 1
low) will be referred to simply as the pump.
Timeouts refer to a preset length of time that a function is
programmed to operate before shutting off automatically.
Certain conditions (filters or freeze) can cause a function to
operate longer, while faults can cause a function to operate
for a shorter length of time. The system keeps track of
timeouts regardless of other conditions occurring.
In multi-button sequences, if buttons are pressed too quickly in sequence, they may not register.
Initial Start-up
When your spa is first actuated, it will go into Priming mode (after displaying some configuration information).
The Priming mode will last for up to 4 minutes and then the spa will begin to heat the spa and maintain the
water temperature in the Standard mode. You can exit Priming mode early by pressing “Warmer” or “Cool.”
Note:
Alternate panel may have an Auxiliary button in place of
a Jets 2 button
Icon Legend
Heat Icon - Indicates different stages of heating.
Jets Icon - Spins fast on high speed; spins slow
on low speed.
1. Setting the Time
Once the spa has been properly connected, notice the
“Time” icon appearing on the screen.
Press
Then
Select
the hour by pressing
Or
(Each press changes the time by 1 hour)
Press
to
enter
Select
minutes by pressing
Or
(Each press changes the time by 1 minute)
Press
Press
to exit the time setting procedure
and enter the optional filter cycle
programming.
to exit programming.
Light Icon - On dim, the LCD will show the center
circle plus one quarter of the light beams. Half of the
light beams will show on medium brightness, and all
of the light beams will show on bright.
2. Optional Filter Cycle Programming
You are not required to set filter cycles; however, it is
an option available to you. To change the filter cycle
settings: Press “Time” “Mode/Prog” “Mode/Prog” “Mode/
Prog” within 3 seconds. You will see the “PROGRAM,”
“FILTER 1” and “START TIME” icons appear on the dis-
play. Press “Warmer” or “Cooler” to choose the filter
start time hour. Enter the hour by pressing “Mode/
Prog” . Press “Warmer” or “Cooler” to choose the filter
start time minutes. Each press changes the start time by
5 minutes. Enter the minutes by pressing “Mode/Prog.”
Press “Mode/Prog” to see the “PROGRAM,” “FILTER 1”
and “END TIME” icons. Adjust the time as done above.
Press “Mode/Prog” to see the “PROGRAM,” “FILTER 2”
and “START TIME” icons. Proceed as above.
Press “Mode/Prog” to see “PROGRAM,” “FILTER 2” and
“END TIME” icons. Adjust the time as done above.
Pressing “Mode/Prog” will enter the new filter cycle
times into the system and display the current water
temperature.
Pressing “Time” at any time during this programming
sequence will save the values entered up to that point
and exit programming.
If you would like to select
continuous filtratio
n, set the
filter 1 start and end times to be the exact same time.
Press
to exit programming.
Press
to enter.
Select
min-
utes by pressing
Or
(Each press changes the time by 1
hour) (Each press changes the time by 1 minute)