Page 18
Bullfrog Spas Owner’s Manual
Warmer / Cooler
Press the “Warmer” or “Cooler” button once to display the set temperature. Each time either button is pressed
again, the set temperature will increase or decrease depending on which button is pressed. After three seconds,
the LCD will automatically display the last measured spa temperature.
Time
When time hasn’t been programmed, the TIME icon flashes. To set the time, press “Time” then “Mode/Prog.” Use
the “Warmer” and “Cooler” buttons to adjust time. See previous page for more detailed instructions.
(Time set-
tings on BFO1 are not preserved in the event of power loss; time will have to be reprogrammed upon each power
up.)
Mode/Prog
This button is used to switch between standard, economy, and sleep modes. Press “Mode/Prog” to enter mode
programming, press “Cooler” to cycle through to desired mode (LCD flashes until confirmed), then press “Mode/
Prog” to confirm selection.
Standard mode
maintains the desired temperature. Note that the last measured spa temperature displayed is
current only when the pump has been running for at least 2 minutes. The “STANDARD” icon will display until the
mode is changed.
Economy mode
heats the spa to the set temperature only during filter cycles. The “ECONOMY” icon will display
until mode is changed Pressing “Jets 1” while in Economy mode puts the spa in
Standard-In-Economy mode,
which operates the same as Standard Mode, then reverts to Economy Mode automatically after 1 hour. During
this time, a press of the “Mode/Prog” button will revert to Economy Mode immediately.
Sleep mode
heats the spa
to within 20°F (1
1°C)
of the set temperature only during filter cycles. The “SLEEP” icon will display until mode is
changed.
Standby Mode
Pressing “Warmer” or “Cooler” then “Jets 2” or “Auxiliary” will turn off all spa functions temporarily. This is helpful
when changing a filter or JetPak. Pressing any button resets the spa.
Jets 1
Press the “Jets 1” button once to turn pump 1 on or off, and to shift between low and high speeds (if equipped). If
left running, the low speed turns off after 4 hours and the high speed turns off after 30 minutes.
The low speed of pump 1 runs when any other pump is on. It may also activate for at least 2 minutes every 30
minutes to detect the spa temperature (polling) and then to heat to the set temperature if needed, depending
upon mode. When the low speed turns on automatically, it cannot be deactivated from the panel; however, the
high speed may be started.
Jets 2 (optional on BF01)
Press the “Jets 2” button once to turn pump 2 on or off, and to shift between low and high speeds. If left running,
the pump will turn off after 30 minutes.
Option
This button does nothing by itself; however, it is used as part of the Invert sequence (see below).
Invert
Press the “Warmer” or “Cooler” button, followed by the “Option” button to change the numbers in the display to
read upside down.
Light
Press the “Light” button to turn the spa light on and off, and to shift between dim and bright settings if your light
is dimmable. On dim, the LCD will show center circle plus one quarter of the light beams. Half of the light beams
will show on medium brightness, and all of the light beams will show on bright.
If the light is left on, it will automatically turn off after 4 hours.
Preset Filter Cycles
On all systems, the pump and the ozone generator** will run during filtration. At the start of each filter cycle, the
lowest speed of pump 2 will run for 5 minutes.
