Page 22
Bullfrog Spas Owner’s Manual
•
The Style of JetPak (J03=Style Number 03)
•
The Water Flow-Rate of the JetPak (63=63 Gallons
Per Minute)
•
The Number of Jets (12=12 Jets)
INTERCHANGING JETPAKS:
1. Put the spa in "Standby Mode". This will prevent the
pump(s) from activating while interchanging JetPaks. (See
"Standby Mode" under "OPERATION" in this Manual.)
2. Remove the headrest pillow (Fig. M-1).
3. Using your hands, remove the SnapCap (top mounting
plate) by lifting it upward (Fig. M-2).
4. Push the JetPak forward until you have enough room
to reach the two PVC water unions and air line union.
5. Disconnect the air line union (Fig. M-3).
6. After loosening the 2 PVC unions (Fig. M-4), pull the
manifold out from between the two water unions and
then remove the JetPak from the JetPod (Fig. N).
7. Exchange the JetPak with another JetPak.
8. Reattach the JetPaks in the same manner as above.
IMPORTANT WARNING:
Spa models with 2 pumps have
2 different jet zones. These JetZones are divided by a
JetZone Divider (see “JetZones in this manual). Never
operate the spa without the JetZone Divider in place.
Doing so, will cause serious damage to your pump(s).
Also,
interchanging JetPaks from one JetZone (see
“JetZones” in this manual) to another may result in
improper water flows to one or more JetPaks. If you have
questions or problems, please consult your authorized
Bullfrog Portable Spa Dealer.
JETTING:
JET TYPES
(Fig. O)
Depending on the model, your Bullfrog Portable Spa
comes with a unique combination of the following jets:
Name Flow
(Figure N) Remove JetPak
(Figure M-1) Remove Pillow
(Figure M-2) Remove SnapCap
(Figure M-3) Disconnect Air Line Union
(Figure M-4) Loosen JetPak Unions