Page 28
Bullfrog Spas Owner’s Manual
Note 1:
Drain water to an area that can handle the gallonage of your spa.
Note 2:
If draining water onto vegetation, make sure that the
sanitizer level (bromine or chlorine level) of your spa water is
less than .5 PPM.
Steps to Drain Your Spa (Conventional Method):
1. Disconnect electrical power supply.
2. Remove door to Equipment Compartment.
3. Drain water from spa by completing the following:
a. Locate Drain Hose in Equipment Compartment.
b. Lift Drain Hose higher than water level in spa.
c. Remove cap on Drain Hose (Fig. S).
d. Connect garden hose to Drain Hose.
e. Lower Drain Hose to ground level.
4. Clean the spa shell (refer to "Spa Shell Care" in this Owner's
Manual).
Steps to Drain Your Spa (Using the Optional PowerDrain™ w/ 50’ of Drain Hose):
*Items Needed:
1 or 2 JetZone dividers
1. Place the spa into standby mode through the control panel.
2. Remove the 1st JetPak on the left side of the spa, nearest the filter assembly.
3. Remove the filter(s) from the filter housing unit.
4. Install the power drain unit on the water output side of the 2" plumbing entering the 1st JetPak recess (this will
be the fitting closest to the control panel).
5. Unroll the drain hose and direct where the output of the water will go.
6. Start “Jets 1” button on low speed (water output volume can be controlled by using the gate valve supplied).
7. Place the JetZone divider(s) into the filter housing blocking off the flow at the bottom of the filter. This will allow
the spa to drain down to the level of the intake suction.
8. The spa water will now drain out of the tub in about 5 to 9 minutes at full volume on low speed.
9. After water is drained, place in standby mode and reverse the above procedure.
Steps To Refill Your Spa:
1. Remove garden hose from Drain Hose and replace Drain Hose Cap.
2. Reattach door to Equipment Compartment.
3. Refill spa with tap water. Fill the spa to any point between the two Water Level Indentation marks located on the
(Figure S) Drain Cap