Page 30
Bullfrog Spas Owner’s Manual
3. Locate the back of the Spa Light Fixture (Fig. U).
4. Grasp the light bulb holder located on the back of the
Spa Light Fixture. Twist counter-clockwise to release it
from Spa Light Fixture. Pull light bulb holder out of Spa
Light Fixture.
5. Replace light bulb and reinstall light bulb holder into
Spa Light Fixture.
6. Replace door to Equipment Compartment and restore
the electrical power supply.
Note:
For alternate lighting systems contact your
authorized Bullfrog Spa Dealer for service.
OZONE STERILIZER REPLACEMENT
On the front of your Bullfrog Ozone Sterilizer (optional) is
an ozone indicator light (the Ozone Sterilzer is located in
the equipment compartment). This indicator light will glow
whenever ozone is being produced.
To verify that your Ozone Sterilizer is working properly,
check the indicator light when the filter pump is running
and only during a preprogrammed filter cycle, making sure
that the indicator light glows (do not check the indicator
light if you have activated the jets within the previous 30
minutes - as a safety device, your Ozone Sterilizer shuts
down for 30 minutes after the “Jets” button has been
pressed).
If the indicator light does not glow when the filter pump is
running then your Sterilizer is not working properly. When
this occurs, take the following steps:
1. Disconnect electrical power supply.
2. Locate the Ozone Sterilizer (Fig. V).
3. Unplug the Ozone Sterilizer's power supply cord from
your spa's Control Center.
4. Disconnect the output tubing from the Ozone Sterilizer.
5. Remove the mounting screws that hold the Ozone
Sterilizer in place.
6.Take the entire Ozone Sterilizer to your authorized
Bullfrog Portable Spa Dealer. Your Ozone Sterilizer will be checked to verify that it is defective. If defective, then
replace the entire Ozone Sterilizer with a new one.
Note:
If your Ozone Sterilizer is found to be working properly, then you may have a problem with your spa's
Control Center or Control Pad. Consult your dealer and request a service call.
7. Reinstall the Ozone Sterilizer by reversing the above procedure.
SPA SHELL CARE
Your Bullfrog spa surface is durable and easy to clean:
Quarite
® and
Altair® Spa Surfaces:
(Figure V) Ozone Sterilizer Location
(Figure U) Light Bulb Location
