22
5. Perform an initial fill as described above. This procedure will take about 10 minutes.
6. The printer will begin to charge the system with the maintenance fluid. This procedure
will take about 10 minutes.
7. Remove the LK, C, M, LC, and LM cartridges and replace with blocking cartridges.
8. Perform two initial fills as described above, with blocking in all but the black and yellow.
9. Remove the maintenance cartridges from the black and yellow and replace with
draining cartridges.
10. Perform an initial fill as described above. This procedure will take about 10 minutes.
Exit Override Mode
•
After flushing the JetPlate, the printer needs to be returned to normal mode.
1. Turn the JetPlate off’
2. Enter the service mode by pressing Paper
Paper Feed Down + Cut/Eject
while turning on the printer.
3. Press Paper Feed Down x2 to Service
Config, and then hit Select Type.
4. Press Paper Feed Down x5 to ED Mode,
then hit Select Type.
5. Press Paper Feed Down until X is present.
6. Hit Enter, Confirm that an Asterisk is next to X.
7. Turn off the JetPlate.
Charge with Plate Marker Fluid
•
The last step is to charge the JetPlate 7600 with PlateMarker.
1. Remove
ALL
the cartridges from the JetPlate.
2. Load Plate Marker Fluid into the Yellow and Black Channel.
3. Load Maintenance fluid into the remaining Channels.
4. Perform an initial Fill as described above. This procedure will take about 10 minutes.
All Trademarks used in this document are the properties of their respective owners. Rev. 1.3 4/6/2004
