Jets Munt M-XBL Series, Instruction Manual

Page 15

JETS MUNT S.L

WHAT TO DO IN THE CASE OF AN EMERGENCY

  During the start sequence the Ecu will be in charge of everything, controlling temperature
and RPM. The only thing the user can do is to abort the sequence by lowering the trim in the
case that something abnormal (excessive flames in the exhaust, etc).

  If a problem is detected, first:

  Move the trim to the low position to abort the sequence.

  If there is a fire in the engine and the problem is because the starter has failed or the
engine is seized (not turning), 

IMMEDIATELY APPLY THE FIRE EXTINGUISHER

 through

the intake side of the engine, never trough the exhaust.

  If there is a fire, but the rotor remains free to spin and the starter is OK, raise the trim
and stick to the full power position for 3 seconds, this will connect the starter manually to
ventilate the engine and extinguish the fire.

  The throttle channel acts as a starter switch.
USE SHORT BURSTS OF STARTER. Using the starter for long time can destroy the
starter motor. 

List of ECU message codes

  Here is a list of possible messages shown on the data terminal screen and their meaning.

  TrimLow:

 Indicates that the signal received from the transmitter corresponds to the

  lowered trim, that is to say, engine OFF.

  Ready:

 Indicates that the engine is ready for starting, and that the transmitter signal

  corresponds to IDLE, (LED lit twice)

  StickLo!:

 This indicates that the throttle stick is in a position above IDLE, the engine will

  not start with the stick in this position.

  Glow Test:

 Verification of glow plug

  StartOn:

 Test of the starter

  Ignition:

 Gas ignition phase.

  Preheat:

 Phase of heating of the combustion chamber after detecting

  the ignition.

  FuelRamp:

 Phase of acceleration until idle speed.

  Running:

 Engine working correctly, pilot have full control of engine power.

  Stop:

 Engine off.

  Cooling:

 Starter operating to cool the engine.

  GlowBad:

 Defective or disconnected glow plug.

  StartBad:

 Defective starter, insufficient RPM reached during start, RPM sensor damaged.

  Low RPM:

 Engine had been shutdown because the speed has fallen below the minimum.

  HighTemp:

 Excessive temperature

M-XBL Series Instruction Manual