VT80BL Instruction Manual
Page 18
JETS MUNT S.L
Other useful information and installation tips:
Extra ECU functions
The ecu provides several menus that allow doing some tests and personalizing some
settings,
Like:
-Adjust the thrust/throttle curve (Linear, Expo, Intermediate).
-Test the starter, Glow Plug, valves and Pump.
-Check the failsafe counter (time and pulses of wrong RC signal).
-Reduce the maximum power.
-Increase the Idle Rpm.
-Adjust the glow plug voltage. The engine come from factory with this voltage adjusted for
reliable starts and long life of the glow plug element. Increasing the voltage beyond the
necessary will cause the failure or shortening of the life of the element. Do not change the
voltage, please contact to Jets Munt first.
-Adjust the pump power at startup. The fuel flow during ignition phase must be finely tuned
for each engine/pump combination, and this is done at factory during test. In the case that
after some run time the pump become loose and the starts become too aggressive, reduce
the value by 2 units at time until normal starts are reached again.
