6
Model #: JHUM90 | Version #: 1
ATTACHING THE REFLECTORS AND BELL
To attach the reflectors and bell, you will need a Phillips head screwdriver. Align
the accessory onto the proper place on the frame: usually, the red reflector is on
the rear, the white reflector is on the front, and the bell is on the left side of the
handlebar. Once the accessory is in the proper location, tighten into place using
the Phillips head screwdriver.
ATTACHING THE PEDALS
To attach the pedals, you will need a #15 wrench or spanner.
The two pedals will be labeled with
R
(for Right) and
L
(for Left).
Line up the #15 wrench or spanner, as seen above, then twist the pedals toward
the front of the bike until they are securely attached.
WHEEL RIM MAINTENANCE
There is a safety line etched into the wheel rim, about 3mm above the lip of the
rim. If the rim has been worn down close to the depth of the safety line, please
replace the rim. A rim that has been worn down that drastically is a danger and
increases the likelihood of an unnecessary accident.
Adjust the spokes every 3 months to avoid distorting the rim in this way.
