47
TO RAISE OR LOWER THE SEAT:
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. RAISE OR LOWER THE SEAT TO THE DESIRED POSITION WITHOUT EXPOSING THE “MINIMUM INSERTION” MARK ABOVE
THE CLAMP.
TROUBLESHOOTING:
IF THE SEAT CLAMP IS TOO TIGHT FOR THE POST TO SLIDE UP AND DOWN EASILY, WIDEN THE
CLAMP OPENING BY TURNING THE CLAMP KNOB COUNTERCLOCKWISE.
3. HOLD THE SEAT IN PLACE AND CLOSE THE SEAT LATCH. IF NECESSARY, TIGHTEN THE CLAMP BY TURNING THE KNOB
CLOCKWISE.
4. CHECK THAT THE SEAT IS SECURE: USE YOUR HAND TO PUT DOWNWARD PRESSURE ON THE SEAT. IF THE SEAT POST
SLIPS FURTHER DOWN INTO THE TUBE, BRING IT BACK TO POSITION AND TIGHTEN THE CLAMP FURTHER WITH
ADDITIONAL CLOCKWISE TURNS OF THE KNOB.
TROUBLESHOOTING:
IF YOU CANNOT OPEN AND CLOSE THE LATCH, THE KNOB MAY BE TOO TIGHT. LOOSEN THE KNOB
½ ROTATION AT A TIME UNTIL YOU CAN MAKE USE OF THE LATCH.
SEAT CLAMP
CLAMP LATCH
CLAMP KNOB
(
opposite
side
-
not
shown
)
Summary of Contents for Journey 3.0
