18
4
OPERATION
INFORMATION FOR THE USER OF THE UNIT
4.1 Starting the unit
Before swivelling the nozzle, switch off the pump.
When you press the pneumatic button (1), this switches the unit ON or OFF.
When using a separate waterproof switch for remote control the unit can
also be operated from outside the pool. The nozzle (6) can be swivelled in
any direction within a cone of about 30°.
Before swivelling the nozzle,
you must definitely switch the unit off.
4.2 Strength of the jet
The JETSTREAM has considerable energy,
therefore reduce the setting!
The strength of the jet is reduced by turning the nozzle head (3) clockwise. Note that a small flow will always occur thus
preventing damage to the pump.
4.3 Massage
Before massage, you must definitely reduce the jet pressure.
Do not utilize full thrust against soft parts of the body
For large-area massage, reduce the strength to half thrust
In order to attach and detach the massage fitting switch off the pump
For point massage, hold the nozzle of the massage hose firmly in your hand under water. Guide the nozzle
of the massage hose over the required places but at some distance from them.
•
Massage hose
When you wish to put the massage hose on or take it off, you must first switch off the JETSTREAM
equipment.
Put the massage hose into the nozzle (2) and secure it with the aid of the movable ring. To take the massage hose off, hold
the hose with one hand, and with the other hand release the movable ring by moving it towards the hose. You can now
pull the hose off the nozzle.
•
Spot massage
For specific massage of particular parts of the body and muscles, use the massage hose with the little nozzle. When
doing so, hold the nozzle of the hose firmly in your hand under water, and guide the nozzle over the required place but
at some distance from it. The shorter the distance between the nozzle and the part of the body that is to be massaged, the
stronger the massage pressure.
•
Back massage
Massaging the back by means of the massage hose without the assistance of another person is very difficult. Therefore,
use the special nozzle for back massage; you attach this to the jet nozzle in the same way as you attach the massage
hose. Position yourself with your back to the nozzle. The shorter the distance between the nozzle and your back, the
stronger the massage.
Before massage, you must definitely reduce the jet pressure.
•
Surface massage
Reduce the jet to half strength. Simply position yourself directly in front of the nozzle. The broad pressure-jet powerfully
massages your skin, the tissue beneath it, and your muscles. This promotes the circulation of the blood, loosens you up
and relaxes you.
4.4 Swimming against the Current
Select maximum flow and the jet direction so that the layer of water just under the surface is made to flow strongly, without
excessive effervescence being visible on the water surface.
4.5 Winterization
If the unit is installed in a pool where there is a danger of frost, the water level has to be reduced to the lowest point of the
unit. Close the valve on the suction side, then unscrew the discharging screw at the underside of the pump.
Do not screw the discharging screw in again after having emptied the pump.
nozzle
head (2)
pneumatic
button (1)
nozzle (3)
