background image

5

© 2013 Jetta Corporation

All rights reserved. REV 05/2013

www.jettacorp.com

owner’s manual

safety instructions

IMPORTANT: READ AND fOllOw All INSTRUCTIONS PRIOR TO INSTAllATION 

AND USE.  SAvE ThESE INSTRUCTIONS fOR fUTURE REfERENCE.

Operational:

Do not permit children to use unit unless they are closely supervised at all time. Supervision is also required when 

1. 

the bath is used by an elderly or handicapped individual. 

Use this unit only for its intended use as described in this manual. Only use attachments recommended by the manufacturer. 

2. 

Do not insert any object into any opening. Do not operate electrical appliances while in or within 5 feet of the bath. 

3. 

Do not operate this unit without the guard over the suction fitting. Long hair must be kept away from the suction 

4. 

screen to avoid entrapment. If entrapment occurs, immediately turn unit off. 

Do not start pump before unit is filled with water 2” above jets – this will void the warranty.

 

5. 

Water level should not exceed the lowest edge of the overflow or controls. 

 

6. 

The water in a whirlpool should not exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C 

7. 

(104°F) are typically considered safe for a healthy adult. Prolonged immersions in hot water may produce hyper

-

thermia. The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, 

lethargy, drowsiness and fainting, which can be fatal. Lower temperatures are recommended for extended use 

(exceeding 10-15 minutes) for young children.

 

Exposure to very hot water has the potential to cause fetal damage during the early months of pregnancy. Preg-

8. 

nant, or possibly pregnant women should limit water temperature to 38°C (100°F). Consult a

 

physician before using. 

Persons using medication should consult a physician before using a whirlpool since medication may induce drowsi-

9. 

ness, affect heart rate, blood pressure and circulation. The use of alcohol, drugs or medication before or during 

whirlpool use may lead to unconsciousness with the possibility of drowning. 

Persons suffering from obesity or with a medical history of heart disease, low or high blood pressure, circulatory 

10. 

system problems, or diabetes should consult a physician before using a whirlpool.  

Electrical:

This unit must be connected to a supply circuit that is protected by a ground-fault-circuit-interrupter (GFCI). Such 

1. 

a GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, push the 

test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to 

operate in this manner, there is a ground current flowing indicating the possibility of an electric shock. Do not use 

this unit. Disconnect the unit and have the problem corrected by a qualified service representative before using. 

 

Disconnect power before servicing.  

2. 

Whirlpool Pump Connections Only: 

3. 

 

a. A green colored terminal (or wire connector marked “G”, “GR”, “Ground” or “Grounding”) is provided within the 

terminal compartment. To reduce the risk of electric shock, connect this terminal or connector to the grounding ter-

minal of your electric service or supply panel with a continuous green insulated copper wire equivalent in size to the 

circuit conductors supplying this equipment. 

 

b. A pressure ground connector is provided on the exterior of the terminal box within this unit to permit connection 

of a No. 8 AWG (8.4mm²) solid copper bonding conductor between this unit and all other electrical equipment and 

exposed metal in the vicinity, as needed to comply with state and local requirements.  

For whirlpools and soakers the Mood or LED light option has its own separate power cord and must be plugged in.  

4. 

Install to permit access for servicing (for built-in and custom units).

 

5. 

Installer / Owner bears all responsibility to comply with all state and local codes when installing this product. 

6. 

Summary of Contents for Baths
















Reviews: