9
© 2013 Jetta Corporation
.
All rights reserved. REV 05/2013
www.jettacorp.com
owner’s manual
operating instructions
Classic Series
The bath should be filled 2” over the directional jets
BEFORE
turning the pump on.
Directional Body jets:
To increase the directional jet pressure, grasp the outer ring of
the jet and turn clockwise, to reduce jet pressure turn the outer
ring
counter-clockwise.
To adjust the jet direction, use your finger to position the jet
nozzle to the desired location.
To remove jet, grasp the outer ring of the jet and turn counter
clock-wise until the jet clicks – then pull jet out.
To install a jet, insert the jet into the jet housing (do not force
the jet) and turn clockwise until the jet clicks – will pass a
point of resistance.
When bathing is complete, the pump must be turned off and the bath emptied. Adjust the inner
nozzle portion of the all the jets in a downward position while draining the bath, to allow the bath
to drain properly.
