2.5.2
Mounting on the cooler
For optimum heat transfer from the heat sink of the unit to the
corresponding cooler, a heat conducting film is already glued to the cooling
plate of the unit (see Fig. 2.8). On the cooler side, the film is laminated with
aluminum. The device can be mounted or dismounted with the film.
Fig. 2.8
Rear panel with film - JM-3000 Servo amplifier BG1 (ColdPlate)
CAUtIoN
Make sure that there is no dirt between the cooler and the rear of the unit
during installation. If this is not observed, the device will overheat due to the
impaired heat transfer. The result would be the failure of the device.
Jetter AG
27
JetMove 3000
Mechanical installation