Jetter AG
Mechanical installation | 5
JX3-PS1 User Manual
15 / 24
5 Mechanical installation
This chapter describes how to install and replace the JX3-PS1.
5.1 Installing the device on the DIN rail
NOTICE
Functional impairment caused by unfavorable installation
►
Install the device only in vertical position on the DIN rail (DIN EN 60715).
►
Keep the minimum distance to surrounding parts.
1
2
Fig. 6:
Installing the device on the DIN rail
1
DIN rail
2
Upper latch
3
Minimum distance to surrounding parts = 30 mm
1.
Disconnect the system from the power supply.
2.
Place the upper latch (2) in angled position on the DIN rail (1).
3.
Snap the lower latch of the device onto the lower edge of the DIN rail.
4.
Slide the device to its intended position.
