6
Chapter 2
Hardware installation
2-1 Hardware installation Steps
Before using your computer, you had better complete the following steps:
1.
Check motherboard jumper setting
2.
Install CPU and Fan
3.
Install System Memory (DIMM)
4.
Install Expansion cards
5.
Connect IDE and Floppy cables, Front Panel /Back Panel cable
6.
Connect ATX Power cable
7.
Power-On and Load Standard Default
8.
Reboot
9.
Install Operating System
10.
Install Driver and Utility
2-2 Checking Motherboard’s Jumper Setting
(1) CMOS RAM Clear (3-pin) : JP4
A battery must be used to retain the motherboard configuration in CMOS RAM short 1-2
pins of JP4 to store the CMOS data.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JP4 and short pins 2-3 for a few seconds
4.
Return JP4 to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1.
Troubleshooting
2.
Forget password
3.
After over clocking system boot fail
CMOS RAM Clear Setting
JP4
1
3
2-3 closed Clear CMOS
JP4
1
3
1-2 closed Normal (Default)
