15
Notice: When all necessary installations are finished, please make sure that all cables
unplugged before installations are connected to their original locations before restoring the
back cover to the chassis and screws on the front panel/back panel/top cover locked to its
original locations (Refer to Part I). See to it that the cables inside are not blocked or pressed.
VII. To Wall Mount the system
1. Install wall mount rack to the system by tightening two screws in the marked positions.
2. Then lock the other two screws on the other side in the same way.
3. Wall mount the system by tightening 4 screws in the marked positions on both sides of the wall
racks.
*Note:
The 3 smaller holes on both sides of the rack are reserved for DIN rail installation. See to
it that the three smaller screw holes on one installed rack should be parallel to those on the other
rack; otherwise please readjust the racks for correct installation.
Summary of Contents for FDF20
Page 2: ...2 I O Outlets ...
