23
Wake-up System with Dynamic Time
Use this item to enable or disable system wake on alarm event.
System will wake on the current time + Increase minutes.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the current time + increased
minute(s).
PS2 KB/MS Wake-up
The optional settings: [Enabled]; [Disabled].
Use this item to enable or disable PS2 KB/MS wake-up from S3/S4/S5.
**Note: This function is supported when
‘
ERP Support
’
is set as [Disabled].
USB S3/S4 Wake-up
Use this item to enable or disable USB S3/S4 wakeup. This function is only
supported when ERP function is disabled.
**Note: This function is supported when
‘
ERP Support
’
is set as [Disabled].
USB S5 Power
Use this item to enable or disable USB power after power shutdown.
**Note: This function is supported when
‘
ERP Support
’
is set as [Disabled].
Internal USB Port S5 Power
Use this item to enable or disable USB power after power shutdown.
**Note: This function is supported when
‘
ERP Support
’
is set as [Disabled].
►
Super I/O Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
ERP Support
The optional settings: [Disabled]; [Auto].
This item should be set as [
Disabled
] if you wish to have all active wake-up
functions.
►
Serial Port 1 Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps]; [RS232 =1Mbps,
RS422/RS485=10Mbps].
Serial Port FIF0 Mode
The optional settings are: [16-Byte FIF0]; [32-Byte FIF0]; [64-Byte FIF0]; [128-Byte
FIF0].
►
Serial Port 2 Configuration/ Serial Port 3 Configuration/ Serial Port 4
Configuration/ Serial Port 5 Configuration/ Serial Port 6 Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
