28
GTT Size
The optional settings are: [1MB]; [2 MB].
Primary IGFX Boot Display
Use this item to select the video device which will be activated during POST. This
has no effect if external graphics present. Secondary boot display selection will
appear based on your selection.
The optional settings are: [VBIOS Default]; [HDMI]; [LVDS].
* Note: [LVDS] option only shows up when ‘Active LVDS’ item is set as [Enabled].
Active LVDS
The optional settings are: [Disabled]; [Enabled].
[Disable]: VBIOS does not enable LVDS.
[Enable]: VBIOS enable LVDS driver by integrated encoder.
* Note: When set as ‘Enabled’, user can make further settings in ‘LCD Panel
Type’
LCD Panel Type
Use this item to select LCD panel resolution.
The optional setting are: [640 x 480 18-bit]; [800x 600 18-bit]; [1024 x 600 18-bit];
[1024 x 768 24-bit]; [1280 x 720 18-bit]; [800 x 480 18-bit]; [1366 x 768 18-bit];
[1440 x 900 18-bit]; [1366 x 768 24-bit]; [1440 x 900 24-bit]; [1280 x 1024 24-bit];
[1400 x 1050 24-bit]; [1600 x 900 24-bit]; [1680 x 1050 24-bit]; [1600 x 1200 24-bit];
[1920 x 1080 24-bit].
South Bridge
Press [Enter] to make further setting in the following sub-items:
Mini PCIE
The optional settings are: [Enabled]; [Disabled].
Mini PCIE Speed
The optional settings are: [Auto]; [Gen2]; [Gen1].
Onboard PCIE LAN
The optional settings are: [Enabled]; [Disabled].
Audio Controller
Use this item to control the detection of the Azalia HD Audio device.
The optional settings are: [Disabled]; [Enabled].
[Disabled]: Azalia will be unconditionally disabled;
[Enabled]: Azalia will be unconditionally enabled;
Azalia HDMI Codec
Use this item to enable or disable internal HDMI codec for Azalia.
The optional settings are: [Enabled]; [Disabled].
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
USB 3.0 Support
This item is for user to select mode of operation of XHCI controller.
The optional settings are: [Enabled]; [Auto]; [Disabled].
USB 2.0 Support
This item is for user to control the USB EHCI (USB2.0) functions. One EHCI
controller must always be enabled.
The optional settings are: [Enabled]; [Disabled].
System state after Power Failure
