33
ownership change should be claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings: [Disabled]; [Enabled].
USB hardware delays and time-outs:
USB transfer time-out
Use this item to set the time-out value for Control, Bulk, and Interrupt transfers.
The optional settings: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device Start Unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select
[Manual]
you can set value for the following sub-item: ‘
Device power-up
delay in seconds
’
,
the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings: [Disabled]; [Enabled].
When set as
[Enabled]
, the following sub-items shall appear:
IPv4 PXE Support
Use this item to enable IPv4 PXE boot support. When set as [Disabled], IPv4 boot
support will not be available.
The optional settings: [Disabled]; [Enabled].
IPv6 PXE Support
Use this item to enable IPv6 PXE boot support. When set as [Disabled], IPv6 boot
support will not be available.
The optional settings: [Disabled]; [Enabled].
PXE boot wait time
Use this item to set wait time to press [ESC] key to abort the PXE boot.
Use either [+] / [-] or numeric keys to set the value.
Media detect count
Use this item to set number of times presence of media will be checked.
Use either [+] / [-] or numeric keys to set the value.
NVMe Configuration
Press [Enter] to view current NVMe Configuration.
*
Note
: options only when NVME device is available.
Intel(R) Ethernet Connection (3) I225-V - XX:XX:XX:XX:XX:XX
This item shows current network brief information.
Intel(R) Ethernet Connection (13) I219-LM - XX:XX:XX:XX:XX:XX
This item shows current network brief information.
