30
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
*When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first
(refer to
JAT_ATX
jumper setting for
Pin1&2 of
ATX Mode &
Pin 2&3 of A
T Mode Select)
Case Open Detect
Use this item to detect Case has already open or not. Show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as
[Enabled]
, system will detect if COPEN has been short or not (
refer
to COPEN jumper setting for Case Open Detection
); if Pin 1&2 of
CASE OPEN
are short, system will show Case Open Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for
‘
SmartFan Configuration
’:
SmartFAN Configuration
CPUFAN1 / SYSFAN1 / SYSFAN2 Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1 full-speed duty. Fan will run at full speed
when above this pre-set duty.
CPUFAN1 / SYSFAN1 / SYSFAN2 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 idle speed temperature. Fan will run at
idle speed when below this pre-set temperature.
CPUFAN1 / SYSFAN1 / SYSFAN2 Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN1 idle speed duty. Fan will run at idle speed
when below this pre-set duty.
Serial Port Console Redirection
COM1
Console Redirection
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Console Redirection Settings
The settings specify how the host computer and the remote computer (which the
