48
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select
[Manual]
you can set value for the following sub-item: ‘
Device power-up
delay in seconds
’
,
the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
Use this item to enable IPv4 PXE boot support. When set as [Disabled], IPv4 boot
support will not be available.
The optional settings: [Disabled]; [Enabled].
Ipv6 PXE Support
Use this item to enable IPv6 PXE boot support. When set as [Disabled], IPv6 boot
support will not be available.
The optional settings: [Disabled]; [Enabled].
PXE boot wait time
Use this item to set wait time to press [ESC] key to abort the PXE boot.
Use either [+] / [-] or numeric keys to set the value.
Media detect count
Use this item to set number of times presence of media will be checked.
Use either [+] / [-] or numeric keys to set the value.
CSM Configuration
Press [Enter] to make settings for the following sub-items:
Compatibility Support Module Configuration
CSM Support
Use this item enable or disable CSM support.
The optional settings: [Disabled]; [Enabled].
