Baby Lock Jewel Service Manual
© Baby Lock, all rights reserved
15
Figure 23
Figure 24
Figure 25
Adjusting the Base Plate Feet and Rollers
Tools required: (5mm handle Allen)
Check:
1. The Base Plate must be adjusted so that the rubber
feet will sit flat on a planed surface.
If a correction is necessary: 0.012” shim washers may be used
as shown in Figures 23 and 24.
Adjustment of Base Plate Rollers:
The base plate rollers must be equally spaced in their respective
positions.
If a correction is necessary:
•
Slightly loosen the front base plate screws.
•
Shift the front base plate until the front and rear wheels
are equidistant as shown in Figure 25.