Baby Lock Jewel Service Manual
© Baby Lock, all rights reserved
26
2. Rotate the Cylinder Tool so that the flat side is
down. (Figure 48)
3. Bring the needle to the lowest point by rotating
the hand wheel. (Figure 49)
4. Slide the Cylinder tool gently against the needle.
(Figure 50)
5. Sight through the needle eye and compare the
upper and lower levels of the eye with the
Cylinder tool groove. If an adjustment is
necessary, loosen the needle bar driving clamp
slightly and raise or lower the needle bar. (#3
Flat-slot screwdriver x 150mm)
6. Reinstall the hook and set loop lift at 2.2mm and
reset needle distance. (See
Adjustment of the
Loop Lift and Needle Distance
Section)
Figure 48
Figure 49
Figure 50
Figure 51