Baby Lock Jewel Service Manual
© Baby Lock, all rights reserved
9
Figure 8
C
C
Removal of the Front Cover
Tools required: 2mm, 3mm, 4mm handle Allen, 4mm L Allen, #3 flat-slot screwdriver,
and #2 Phillips screw driver.
1. Loosen the set screw A in Figure 6, rotate the thread guide
to allow access to the frame screw, then re-snug.
(2mm
handle Allen tool)
2. Remove the three frame screws as shown in Figure 7.
(3mm handle Allen tool)
3. Remove the “C-pod” by unscrewing the 4 screws “C” in Figure
8.
(#2 Phillips screwdriver)
4. Carefully unplug the cables from the C-print and pod
. Be careful
not to touch the C-print.
Figure 9. See plug configuration on
page 8.
A
Figure 6
Figure 9
Figure 7