4. GREASING
Lower the cutter bar again before adding new oil.
When changing the oil, be sure to use a correct oil type.
Only use oil of the quality API GL-4 SAE 80W
In some countries, this oil is not available. In these cases a API GL-4 or API GL-5
SAE 80W-90 multigrade oil can be used as an acceptable alternative. Never use
pure SAE 90W oil in the cutter bar.
WARNING: Never
fill
with
more oil than prescribed.
Too much oil as well as too little oil in the cutter bar may cause
unintentional overheating which in the long term will damage
the bearings.
BEVEL GEARBOX ABOVE THE CUTTER BAR
Fig. 4-5
Oil content:
0.9 l
Oil type:
API GL4 or GL5 SAE 80W -90
Oil level:
n
Check the oil level after every 80 hours of operation.
Oil change:
a
First oil change after 50 working hours and then after every 500
working hours or at least once a year.
BEVEL GEARBOX ON THE HEADSTOCK
Fig. 4-6
Oil content:
540 rpm = 1.1 l
1000 rpm = 1.2 l
Oil type:
API GL4 or GL5 SAE 80W -90
Oil level:
n
Check the oil level after every 80 hours of operation.
Oil change:
a
First oil change after 50 working hours and then after every 500
working hours or at least once a year.
PIGB-093X-06 GX 2402/2802/3202 SM-GX 2402/2802 SC 0410
39
