1. INTRODUCTION
GENERAL SAFETY INSTRUCTIONS
The following is a brief description of the measures, which should be observed by the
operator.
Transport
1 Always lower the cutting unit to the ground or activate the transport safety
device when parking the machine.
2
Never stand between the tractor and the mower during connection and
disconnection.
3 Always drive with the statutory lights and safety marking during transport on
public road and at night.
4 Always use transport safety devices and stop valves for hydraulic cylinders.
5 Limit the transport speed to maximum 30 km/h if the machine has not been
marked with another maximum speed limit.
WORKING
6 During work never wear loose clothes which can be pulled in by the moving
parts of the machine.
7 Use hearing protectors if the tractor has not been silenced sufficiently.
8 Make sure that all guards are intact and have been mounted correctly.
9 When connecting the PTO drive shaft, check for 540/1000 rpm.
10 Never start the tractor until all persons are safely away from the machine.
11 Do not stand near the machine while it is working.
12 Stop the machine if children are near.
13 Never use the machine for other purposes than what it has been constructed
for.
14 Do not stand near – or try to lift a guard – until all revolving parts have stopped
moving. This also applies when adjusting the machine!
15 Always disengage the PTO drive shaft, activate the parking brake and stop the
tractor engine before you adjust the machine.
MAINTENANCE
16 Never work under the machine unless it is secured by means of stop blocks or
other mechanical securing device.
17 Always block the tractor wheels before working under the machine.
18 Always disengage the PTO drive shaft, activate the parking brake and stop the
tractor engine before you
- lubricate the machine,
- clean the machine,
- disassemble any part of the machine,
- adjust the machine.
19 Remember to remove all tools before starting the tractor again.
PIGB-093X-06 GX 2402/2802/3202 SM-GX 2402/2802 SC 0410
8
