RECOMMENDED RECEIVER INSTALLATION
The installation of the equipment in the sound system is done through a
polarized power cable. Make sure the white-striped wire from the receiver
unit is connected to the battery's direct positive (+12V) and the black wire
to the negative (GND).
The receiving unit should preferably be xed away from metal parts and
the car's bodywork (which degrades the transmission) keeping, whenever
possible, the antenna unobstructed to allow the greatest possible range of
the equipment.
Position the infrared emitter, from the receiver unit aimed at the player's
panel, so that there are no obstacles between them. It is recommended to
install the receiver unit in the trunk and the IR emitter in the center of the
rear window, pointing towards the front of the player. Make sure the
wires are not crushed in the installation process.
Infrared emitter
Polarized cable
feed
Unit
receiver
Infrared emitter
Player
K600 REMOTE CONTROL - INSTRUCTION MANUAL
Summary of Contents for K600
