ENGLISH
27
IMPORTANT SAFETY INSTRUCTIONS
Installation location
•
This device is only intended for usage indoors where it is protected. Do not use it outside!
•
Protect this device from extreme heat (over 35°C) and cold (under 5°C) as well as from direct sunlight and
dust.
•
Do not use this device in a very dry environment. This can result in electrostatic discharges.
•
Danger of electrocution!
Never use this device right next to water – e.g. bath tub, sink, water bucket, in a
damp basement or near a swimming pool.
•
Only use this device in temperate latitudes; avoid using it in tropical and in especially damp climates.
•
Do not place any objects with open flames, such as candles, on top of this device.
•
Do not place any objects filled with liquids, such as vases, on top of this device.
•
Make sure that the ventilation of the device is not hindered due to the ventilation openings being covered up
by for example, newspapers, tablecloths, curtains, etc.
•
Leave at least 10 cm of clearance around the device to guarantee proper ventilation.
•
Avoid using it in areas with insufficient ventilation (e.g. on book shelves, behind curtains, between pieces of
furniture).
•
Keep this device away from all heat sources like for example, ovens, hot plates and other heat-producing
devices / objects.
•
In order to reduce the risk of fire and electric shock, do not expose this device to fire (fireplace, barbeque,
candles, cigars, etc.) or water (dripping water, splashing water, vases, bath tubs, ponds, etc.).
Power supply
•
Prior to connecting to the power supply, make sure that the power supply and the type of power correspond
to the information on the label.
•
The power plug is used as the disconnect device. Please be sure that the power plug is in operable
condition.
•
Only removing the power plug can separate the device completely from the mains supply.
•
Only unplug from the power outlet by the plug itself. Do not pull on the cord.
•
Avoid damages to the power cord that may be caused by kinks or contact with sharp corners.
•
Unplug the power cord when not in use, during disruption in operation and before cleaning.
•
Unplug the power cord during lightning storms and prolonged absence in order to protect the electronics
against overvoltage and damage.
•
If the power cord or the casing of the device is damaged or if the device is dropped, the device may not be
used before it is examined by a professional electrician.
•
A damaged power cord may only be replaced by the manufacturer or a workshop commissioned by the
manufacturer or by a similarly qualified person in order to avoid hazards.
•
Protect the power cord and the housing from damage.
•
Attention:
In case of a defect due to electrostatic discharges and power surges, reset the device by
unplugging it.
•
Attention:
In case of a defect due to electrostatic discharges and power surges, reset the USB device by
unplugging it from the playback device.
JGC-MS-8110-IM-DE-EN-V2.indb 27
24/08/2009 4:51 PM
