2
3
4
5
7
10
8
9
6
1
Attach the Rear Wheels │ 5
Rear Bottom View
Remove all the parts from the rear axle.
1. Slide the
rear gear box
onto the rear axle from
Left Side
(“R” labeled gear box should
be fit to the “R” side, “L” labeled gear box should be fit to the “L” side), keep the
connector and the motor on the gear box pass through the larger hole and out where
the battery sits.
2. Slide the
rear wheel
onto the rear axle. Keep it match up with the gear box.
3. Slide a
Ø10 washer
onto the rear axle.
4. Tighten a
lock nut
to the end of the rear axle with a spanner.
5. Fit the
hubcaps
to the wheel.
1WD
HINT: If your vehicle is Two / Four Wheels Driving Type, see the next page please.
6 Slide the
Ø10 washer
onto the rear axle
(Right Side).
7. Slide the
rear wheel
onto the rear axle.
8. Slide the
Ø10 washer
onto the rear axle.
9. Tighten a
lock nut
to the end of the rear axle with a spanner.
HINT: An extra
spanner has been provided to hold the Lock Nut on the other side of the rear
axle while tightening the Lock Nut on the other side.
10. Fit the
hubcaps
to the wheel.
