1
2
3
4
5
Front axle
GAP
After assembling any normal wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below picture), if
the gap is too big, please add two or three washers inside the wheel, But
after tightening the nut outside the wheel, please turn the wheel by your
finger to check if the wheel can run smoothly, this is very important,
because if the wheel can run smoothly, it is ok, but if the nut press the
wheel and the wheel can’t run smoothly, the motor will be broken easily!
Then you need to decrease one or two washers to make sure the wheel
can run smoothly!
Attach the Front Wheels
│
10
Normal Wheel
Front Bottom View
Remove all the parts from the front axle.
1.
Slide a Ø12 washer onto the front axle.
2.
Insert the bushing into the central hole on the wheel.
3.
Slide the normal wheel onto the front axle
4
.
Tighten a Lock nut to the end of the front axle with a spanner.
5
.
“Snap” the hubcap to the wheel cover.
Repeat the above procedure to assemble the other front wheel.
