HOW TO USE THE REMOTE CONTROL
Notice:
1. Take down the screw on the battery cover at the back of the controller and remove the battery cover
2. Add two pcs “AAA” batteries( not included)
3. Assemble the battery cover and tighten the screw to fix the battery cover
forward switch
accelerate switch
Decelerate switch
High speed indicator light
Low speed indicator light
turn left switch
turn right switch
emergency stop switch
power switch/connection
built switch
Normal speed indicator light
press the power switch, the indicator light is on, press again the power switch, the indicator light is
off
First use, please build connection between the car and the remote controller
Turn off the power switch of the car, press the connection built switch around 5 seconds till the lower
speed indicator light is flashing, turn on the power switch of the car, the buzzer sound “Bi” then stop,
if the low speed indicator light change from flashing to on, then the connection is successful
,otherwise you must repeat above steps(normally you must complete above steps within 10
sceonds)
Forward and backward switch controls the direction
Accelerate switch/decelerat switch: can be switched to high/middle/low speed, the indicator light will
tell you which speed you are in
Left and right switch controls the car turn left or right
Emergency stop switch: If any emergency or abnormal things occurred, you can press this switch to
stop the car immediately, all the function will lose efficacy, the indicator light will be flashing, press
this switch again, the car will be normal
1. If the distance between the remote controller and car exceed the “safety distance”, the buzzer will sound “BI BI” ,“BI”(two short
sound, one long sound) to remind parents, if the distance within the “safety distance”, the sound stop
2. When the remote controller is on, the remote controller will connect with the car continuously, if failed by three times, the buzzer
will sound “BI BI” ,“BI”(two short sound,one long sound), if they can connect well, the sound stop
3. If the power of the car is too low, the indicator light will flash quickly, remind parents to recharge the battery
4. If no operation in 60 seconds, the remote controller will begin the sleep mode, “high speed indicator light flash slowly, remind
parents to turn off the power of the remote controller
Remark:
1.remote control and car is one to one, one controller can just operate one car
2.Remote control function is priority to Pedal control, that means if you use the remote control, pedal operation can’t control the car
3.The vehicle will only have low speed when the car move backward
4.When you replaced the remote controller battery, you must build connection between the remote controller and car again
5.remote control can just operated by adult
6.this car with slow start and slow stop function
Use the
2.4G
Remote Controller
│
20
