Trouble
Shooting
Problem
Cat does not mos.
Car was runnnq but
sudden}y stopped
Possible Cause
breaker tnpped
Loose Wire or
OODd batery
Undercharged battery
Charger rot womng
Elec.tnory switch damages
Loose wtre or connectors
Circuit breaker tnpped
Solution
Cir:utt breaker may
•trip•
and stop the vohde
It overloaded or me
driving conditions too severe. The breaker Will atmnaucalty reset anor
approxjmatetv t O seconds. and the vohjcJe
operate normally To avod
repeated automatic chut downs. do not overbad the vohido by exceedng
the welght omit of 40k0. or by towsnq anythsr,9 behind the veh/c'e DO
not dnva uphill or tun into fixed objects. which can calN the wheels to
slop spjnmrg while power sutl being suppbed to the
Check ail wires and connectocv Make sure that the
harness
connector vs plugged in tightly to the battery. and that there are no
loose wtros around tho motor
An old or
cared battery may be dead
A new battery should have been charged for at least 12 hours before
using the vehicle for the first time Attor that. it must be recharge the
battery tor at toast 8-10 hours after each use Never charge longer than
24 hours Check all connectors: make sore the charger is plugged into
tho wail Make sure the power flow to the outlet is on
You must have a volt meter tn order to ten whether the charger js
working or not,
When exposed to water or motsturo. electricity can become corroded.
or can jam doe to loose dirt. sand or gravel.
Chock all wires and connectors. Make sure that the motoc harness
connector is plugged into the battery tightly. and that there are no
loose wtres around the motor
Circuit breaker may
•trip'
and stop the vehicle d it is overloaded or
the dnvvng conditbns too severe The breaker
automatically
reset after approximatøty 10 seconds. and
vehtcle will operate
normally. To avoid repeated automatic shutdowns. do not overload
the venee by exceeding the weight limit of 40Åg. or by towing
anything behind the vehicle Do not artve uphill or run into fixed
objects. which can cause the wheels to stop spgnning while power
IS st/l beng suppti0d to the motors
