Confidential & proprietary. Copyright 2022 Jigabot LLC, all rights reserved. Info@jigabot.com www.Jigabot.com Ph. 801-995-368 5
Quick-Start Guide
Assembly & Setup
Jigabot EX Twofer
Setup--to keep in mind
EX Bot Twofer is an assembly of two EX Bots: a Lower (for panning or swiveling left and right) and an Upper (for tilting or aiming up and down).
The Lower EX Bot (the one responsible for panning or swiveling) has an angle of view of 26-degrees downward (or upward), or vertical angle of view of 52-degrees total. So for it to
function (pan left and right), the DOTs must not be outside of this line of sight.
If the EX Bot Twofer cannot see the subject’s DOTs, you will need to either decrease the height of the Twofer, or tilt the entire Twofer unit down slightly. NOTE: the Twofer will operate
most smoothly if it is level with the floor (see next few pages for ideal setup). Therefore, decreasing the height of the Twofer where possible, is best.
EX Bot Twofer
elevated relative to
the subject
Subject to track
