JIMTEN Ciclon CC T-604 CC, Installation And Maintenance Manual

3. INTRODUCTION.

The CICLON CC waste disposer is thought to allow the installation and drainage of fixed wall-hung WC
and bathroom facilities (WC, washbasin, bidet or shower) in non-usual places. These facilities can be
placed far and/or at a different level of flush, provided that this flush is placed at a maximum horizontal
distance of 52 m or at a maximum vertical distance of 6 m, or a combination of both as described in this
manual.

The CICLON CC sanitary waste disposer solves the problem of creation and restoration of secondary
bathrooms in places such as: attics, basements, garages, shafts and staircase, offices, factories, restau-
rants, pubs, gyms, shops, etc. and even though thanks to its low sound level a bathroom within a
bedroom.

Our CICLON CC waste disposer is designed to evacuate sewage, defecations and toilet paper. It must
not be installed as food waste disposer connected to kitchen sinks or appliances equipped with pumps
such as washing machines or dishwashers.

Its attractive and practical design perfectly fits into the bathroom and makes easier the concealed insta-
llation and its dismantling in case of maintenance, as thanks to the independence of the motor set from
the rest of the unit, it allows an easy access and a fast replacement thereof, thus avoiding the “out of
service” situation while being repaired.

4. GENERAL DESCRIPTION.

The CICLON CC sanitary waste disposer allows the simultaneous installation and drainage of three
sanitary appliances , placed at a same level (washbasin, bidet or shower) and a lavatory. The wall-
hung lavatory (with a horizontal outlet) is connected to the waste disposer by means of a coupling
(provided), and a frame/tank with the fixing screws (supplied).

The waste disposer consists of two independent modules:

- The sanitary macerator body, formed by a tank and receives all the evacuation connections from

the sanitary appliances and a caset-engine set, removable, which contains all the mechanical
parts: pressure-switch, engine, pump and rotary blades.

-The concealed cistern module, formed by a galvanized steel frame, where the tank/deposit is atta-

ched incorporating all the flush and float valves, a support to which the sanitary macerator body
is fixed, and all the lavatory (not included) fixing tools.

Operating plate and access covers not included (*), a wide range for you to select is available to fit any
bathroom design. (*) depending on versions.

4.1. Operating.

Once the waste disposer is installed, it starts working by activating the discharge of the lavatory cistern
or by means of water supply through the auxiliary connections coming from the rest of the bath applian-
ces connected there to.

Sewage and waste materials pass into the unit and increase the water level. The pressure micro switch
comes on and the motor and the pump are activated.

The blades grind the objects going through the lavatory (or additional inlet by rotating at 2700 r.p.m.
Then the pump drives these materials through the pipe evacuation outlet to a sanitary pipe or flush.

Depending on the height of the vertical discharge pipe, an operating cycle may last between 7 to 12 seconds.

In case of an excessively long operating, or if the waste disposer is started continuously, it is neces-
sary to check if there is any sort of leaking from the cistern to the lavatory or in the rest of the connec-
ted appliances.

INSTRUCTIONS AND MAINTENANCE GUIDE - 21

T-604 CC WASTE DISPOSER

English

Español