JIMTEN Ciclon CC T-604 CC, Installation And Maintenance Manual

5. MOUNTING ASSEMBLY OF SYSTEM.

- Place the CICLON CC in the concealed cistern frame, and the set in a suitable place and connect

every inlet and outlet (see connection figure on page 10). Provide a one meter minimum distance
from the flush to the waste disposer, so that it can operate during the appropriate time to eliminate
the wastes effectively.

- Check the frame position onto the building

structure, adjust its height, so the base of the
macerator body is aligned with the final floor
finished height. Mark drilling points in the back
wall or the light wall structure.  

- Verify all the components of the concealed

cistern, flushing mechanism, float valve, stop
cock, to check they remain in place and not
moved from transport.

- Mount the stopcock in the tank (1/2”), select the

hole depending on water supply position. 

- Screw the frame module to the floor and to the

wall or light structure 

. 

- Prepare the electrical connection before tiling or

closing light wall structure 

.

- 

A normalized IEC electrical base is
recommended to be installed in case
disassembling is needed.

- Install water supply to the ½” supplied inlet and

verify it does not leak 

.

- 

Install protection covers when tiling on
discharge pipe from the tank and waste pipe
from the lavatory to the sanitary macerator unit
until works are finished and the lavatory
installed.

- Thread wall-hung fixing bolts and protect them

(covers supplied) 

.

- Install the selected frontal finishing onto the

concealed cistern (light wall, tiling). Keep register indicated areas (440x310 mm for the bottom,
magnets, push plate). Cutting form is supplied. 

- Cut straight pan connector & lavatory water supply 

to the required length.  Connect both to the

toilet and fix them on the concealed cistern. Verify their correct adjustment free of leakage.

- The CICLON CC waste disposer has 2 lateral auxiliary inlets, by means of a 1 1/2 “ side connection

provided with non-return 

valve and a top auxiliary inlet (1 ½”) to connect a single sanitary appliance

in each. If the side auxiliary inlet is not used, there is a plug to leave it out of action. The unit receives
water from the sanitary appliance by the action of gravity. The horizontal stretch from the waste
disposer must have a positive slope (1%-2%) to allow drainage when the waste disposer is not working.

- When a shower base is connected to the waste disposer, it is essential to provide a minimum height

of 180 mm between the lower part of the shower base and the waste disposer base, thus providing
the necessary slope towards the waste inlets.

- It is recommended to use a non-syphonic waste pipe when installing the shower base and the

bathtub; otherwise, see figure on page 13 to install a secondary ventilation system

22 - INSTRUCTIONS AND MAINTENANCE GUIDE

T-604 CC WASTE DISPOSER

English

Español