INSTRUCTIONS AND MAINTENANCE GUIDE - 27
T-604 CC WASTE DISPOSER
PROBLEM
REASON
SOLUTION
- The motor only works when the WC
is discharged but not with the water
from the other sanitary connected
appliance.
- The auxiliary connection or the non-
return valve is blocked.
- The auxiliary connection lacks ventila-
tion.
- The micro-switch is not working properly.
- Clean the pipe stretches of the auxiliary
connection and the non-return valve.,
- Install a secondary ventilation, or a
Jimten A-69 vac-valve. / Review the
evacuation installation.
- Contact the T.A.S.
- After evacuating the motor starts
continuously before stopping.
- The water returns to the waste disposer.
The non-return valve dos not work
properly.
- Carry out several discharges with clean
water and clean the non-return valve.
- Accumulation of wastes inside
the lavatory.
- Unsuitable water supply from the cistern. - Adjust the water level in the cistern (6
litres minimum).
- The water returns to the shower base.
- The required minimum slope at the
evacuation installation has not been
attained (see shower base height)
- The non-return valve of the auxiliary
connection does not work properly.
- Review the installation (rising the shower
base height)
- Clean and/or replace the item from the
waste disposer.
- Odd noises when the motor operates.
- Obstruction due to a foreign object in
the lavatory.
- Extract the item from the waste disposer
(see 7.3. motor dismantling and remo-
val).
- Nasty smells coming from the waste
disposer.
- Corrosion of the active carbon filter.
- Replace the filter (contact the T.A.S.)
- The shower base does not evacuate
correctly.
- Obstruction on the run pipe.
- Siphoned valve on the shower base,
generates an air piston on the pipe.
- Not enough height in the shower tray
installation.
- Clean the pipe.
- Replace the shower base valve trap
using a non-siphoned valve.
- Review the installation (rising shower
base height)
- Water leakage in the wall
- Review pan connection or c.cistern
water supply.
- Wall-hung toilet breakage.
- Verify water tightness in pan connector
connection and water supply connection
to the wall-hung toilet.
- Substitute defective wall-hung toilet.
- Check the wall-hung toilet has been
correctly mounted onto the screws using
the supplied joints.
- Does not flush after pushing the
operating plate.
- Connection cables broken or incorrectly
installed.
- Defect in the push-plate.
- Defect in the c.cistern flush mechanism
- Remove the push plate, check the
connection of the cable for the simple
and double flush.
- Replace the push plate.
- Replace the flushing mechanism.
- Water loss inside the cistern
- Accumulation of dirtiness in the flushing
mechanism base.
- Faulty float valve.
- Stopcock or water supply flexible with
leakage.
- Faulty flushing mechanism or base.
- Remove push plate, remove the flushing
mechanism, clean joint and base of the
flushing mechanism of any accumulated
sediment and re assemble.
- Remove push plate, access the float
valve and replace with a new one.
- Remove push plate and replace flushing
mechanism.
English
Español
Summary of Contents for Ciclon CC T-604 CC
Page 34: ...34 INSTRUCTIONS AND MAINTENANCE GUIDE T 604 CC WASTE DISPOSER 12 INSTALLATION English Espa ol...
Page 35: ...MANUAL DE INSTRUCCIONES Y MANTENIMIENTO 35 T 604 CC WASTE DISPOSER English Espa ol...
Page 36: ...36 INSTRUCTIONS AND MAINTENANCE GUIDE T 604 CC WASTE DISPOSER 12 MAINTENANCE English Espa ol...
