INSTRUCTIONS AND MAINTENANCE GUIDE - 29
T-604 CC WASTE DISPOSER
ELECTRICAL CONNECTIONS SCHEME.
(motor – pressure switch – power cord).
Network cable
(A)
– Made up of Live (brown), Neutral
(blue) and Earth (Yellow/Green).
Triac cable
(B)
– Live (brown) to connection 3 of pres-
sure switch
(D)
, faston female.
Network cable
(C)
Live (brown) to Triac
(E)
.
Triac cable
(F)
Live (brown) to motor.
Triac cable
(G)
– Live (brown) to connection 1 of pres-
sure switch
(D)
and to motor.
Neutral (blue)
(H)
and Earth (Yellow/Green)
(I)
faston
male connection.
* If power supply cable is damaged, it must be replaced by the manufacturer, its technical assistance
service or a qualified technician to prevent any
danger.
7.4. REPLACEMENT / CLEANING NON-RETURN
VALVE.
Before starting the replacement / clearing,
discharge several times and (if it was previously
installed) to close the stopcock of the vertical waste
pipe and disconnect the unit from the power supply.
- Remove register to access the unit.
- Remove the 1 1/4” nut
(B)
.
- Release the support flanges attaching the pipe
to the wall in order to move the pipe and to
make the dismantling easier.
- Have a container near to collect water, empty
the discharge pipe by activating the non return
valve clapper.
- Remove the clip nut
(C).
- Check or replace the seal s non-return
joint set
(D)
.
- To assemble the valve, follow the steps in reverse order.
Before operating the waste disposer again, and for the purpose of eliminating air within the discharge insta-
llation, discharge the cistern several times.
A
B
C
D
E
F
G
H
I
A
B
C
D
E
F
G
H
I
English
Español
Summary of Contents for T-604 CC
Page 34: ...34 INSTRUCTIONS AND MAINTENANCE GUIDE T 604 CC WASTE DISPOSER 12 INSTALLATION English Español ...
Page 35: ...INSTRUCTIONS AND MAINTENANCE GUIDE 35 T 604 CC WASTE DISPOSER English Español ...
Page 36: ...36 INSTRUCTIONS AND MAINTENANCE GUIDE T 604 CC WASTE DISPOSER 12 MAINTENANCE English Español ...
