Mifare & ISO14443A&ISO7816
http://www.jinmuyu.com
Copyright © 2003-2014 Jinmuyu Electronics Co., LTD. All rights reserved.
11/17
Start sector = 00
End sector = 00
Start block = 00
End block = 02
Start byte = 07
End byte = 06
Then the output data is the red data in the chart:
07 08 09 0A 0B 0C 0D 0E 0F
10 11 12 13 14 15 16 17 18 19 1A 1B 1C 1D 1E 1F
20 21 22 23 24 25 26
5.5.3
Array mode
Name the start block and end block, then start to output the data from the start byte to the end byte, as
the chart:
If set the following parameters:
Start sector=00
End sector=00
Start block=00
End block=02
Start byte=03
End byte=09
Then the output data is the red data in the chart:
03 04 05 06 07 08 09
13 14 15 16 17 18 19
23 24 25 26 27 28 29
5.5.4
Extra key additional
CapsLk setting: Set CapsLk to configure the output of part of card number letter in Upper-case or
Lower-case format.
Extra key setting: Set the key in two positions (Every block end and Data End) after the card number
