PAGE 35 of 53
DJ0050 Rev 05.4
5.
Use the Torx® driver to loosen the wedge separation indicator clamp screw
(Fig. 84).
6.
Slide the wedge separation indicator off the crossbar
(Fig. 85)
.
7.
Using the Phillips driver
(Fig. 24)
,
unscrew the crossbar clamp
bracket screws
(Fig. 86)
.
8.
When the crossbar clamp
bracket screws are removed,
slide the crossbars from the
crossbar clamp bracket
(Fig. 87)
.
9.
Select the length of crossbar
required for appropriate probe
spacing and reverse the
preceding steps
(Fig. 88)
.
Fig. 84
- Loosen the wedge separation indicator clamp screw
Fig. 85
- Remove the wedge separation indicator
Fig. 86
- Remove the crossbar clamp bracket screw
Fig. 87
- Remove crossbars from crossbar clamp bracket
Fig. 88
- Reverse steps using required crossbars