PAGE 103 of 177
CX0344 Rev 05.3
5.9. Slider PPS
(Slider Probe Positioning System)
The slider PPS uses a slide and leadscrew system to manipulate a probes position
along a frame bar. To setup and install a slider PPS follow these steps:
1.
Ease the slider onto the frame bar and push to into position
(Fig. 246)
. The slider’s
friction fit requires an appropriate amount of force to position the slider.
2.
Loosen the slider’s lock knob
(Fig. 246 - note red highlight)
.
3.
Loosen the main knob’s hexagonal screw and lock screw
(Fig. 247 - note red
highlight)
.
4.
Align dovetail nut of the main knob with the frame bar and slide into position
(Fig. 247)
.
Fig. 246 - Place slider on frame bar and loosen slider lock knob
Fig. 247 - Place main knob on frame bar
