PAGE 124 of 177
5.11.3. NAVIC Backpack
Intended Use
►
The
NAVIC
backpack is intended to mount objects
(eg. preamps, splitters, etc)
that:
►
have a maximum weight of 1.36 kg
(3 lb)
►
are attached to the
NAVIC
with a lanyard or probe cables strong enough to
prevent the object from falling
►
have smooth edges so as not to cut backpack velcro strap
To install and use the backpack, follow these steps:
NOTE:
The backpack is only compatible with
NAVIC
crawlers manufactured
after the spring of 2015.
1.
Allow the
NAVIC
crawler to
pivot exposing the inside
of the left drive module
(Fig. 288)
.
2.
Slide the dovetail nuts
of the backpack into the
accessory dovetail groove
(Fig. 288)
.
3.
Tighten the two backpack
screws using the supplied
3 mm hex driver
(Fig. 289)
.
4.
Pull the Velcro straps tight
around the item on the
backpack
(Fig. 290)
.
Fig. 288 - Pivot and insert dovetail nut
Fig. 289 - Tighten screws
Fig. 290 - Use velcro straps
