PAGE 11 of 177
CX0344 Rev 05.3
2.2.3. Pivoting Probe Holder Frame
CXG013-
The Pivoting Probe Holder Frame is intended to be mounted in the NAVIC’s
swivel mount to provide mounting of multiple probe holders. Its use limits the
NAVIC’s operation to the operating limits shown below.
2.2.3.1 Operating Limits
Category
Parameter
Specification
Inspection Surface
Minimum OD,
longitudinal driving
305 mm
(12 in)
Maximum number of probe
holders
Vertical probe holders 6
2.2.4. Frame Bar
BG0038-
The Frame Bar is intended to be mounted in the NAVIC’s swivel mount to provide
mounting of multiple probe holders. Its use limits the NAVIC’s operation to
inspection surfaces that are either flat or driven on in the circumferential direction.
2.2.4.1 Intended Use
Category
Parameter
Specification
Inspection Surface
Minimum OD,
longitudinal driving
Not recommended
Maximum number of probe
holders
Slip joint probe holders 2
Vertical probe holders
2
Heavy duty vertical
probe holders
2
2.2.5. Slip Joint Probe Holder
PHA012-
The Slip Joint Probe Holder is intended to a provide probe holding solution for
probes and wedges with pivot button holes. It is useful for situations requiring
lower profile. It is mounted in the dovetail groove of any probe holder frame or
frame bar.