PAGE 53 of 177
CX0344 Rev 05.3
To configure the
NAVIC
system for scanning using dual drive modules with a
low profile probe holder frame, follow these steps
(see “Low Profile Probe
Holder Frame - Flat or Circumferential Only” on page 110)
:
1.
Mount and connect the
4
umbilical to
2
right drive module of the
crawler.
2.
Attach a configured
1
low profile probe holder frame
(see “Low Profile
Probe Holder Frame - Flat or Circumferential Only” on page 110)
to the
crawler
(see “Umbilical” on page 61)
.
CAUTION!
DO NOT DISCONNECT
UNDER LOAD.
Shut off power before connection or
disconnecting. Permanent damage to electronics
could occur.